In short
If the door won't lift after a loud bang from the garage, a spring has almost certainly broken. Leave the door down, unplug the opener and call; a technician in Princeton fits springs sized to your door, checks the cables and rebalances it.

Springs in Princeton
Riverside and Littlebrook houses from the 1950s to 70s have reached the age where doors are on a second or third set of springs. Low-pitched mid-century garages sometimes use special low-clearance hardware, and replacement parts need to match that layout.
Carriage houses in the Western Section often have custom wood doors of considerable weight. Springs are specified from the measured weight so the door lifts with one hand when disconnected.
How to tell a spring has broken
- A sharp bang came from the garage, like something heavy fell, and nobody was in there.
- The coil spring on the bar above the door now has a visible gap.
- The opener strains, the door rises a few inches and stops.
- With the emergency release pulled, the door feels far heavier than it should.
- One or both side cables are slack or hanging.
Why this isn't a do-it-yourself job
A torsion spring is wound under enormous tension. Replacing one means unwinding and rewinding that tension with steel bars, and a slip can break a wrist or worse. Until it's fixed, keep the door closed, unplug the opener so nobody hits the button, and keep kids and pets away from it.
The repair, step by step
- Secure the door and release the remaining tension safely.
- Fit springs rated for your door's weight. Both are usually replaced, since they wear out together.
- Replace frayed cables and worn bottom brackets if needed.
- Balance the door, lubricate moving parts, and test the opener's safety reverse.
Around Princeton
- Western Section: Historic estates and carriage houses near Library Place and Hodge Road.
- Institute area: Streets around the Institute for Advanced Study and Battle Road.
See the full Princeton service area.
Questions we hear in Princeton
Our house is mid-century modern. Are there doors that suit it?
Yes: flush panels, horizontal planks, and aluminum-and-glass doors all fit that style.
We're in a historic district. Do we need approval for a new door?
Possibly. The town's historic preservation office can confirm; the door is quoted to whatever is approved.